Removing And Installing The Throat Plate - Dürkopp Adler 567 CLASSIC Service Manual

3.3.6 Removing and installing the throat plate

Fig. 6: Removing and installing the throat plate
Removing the throat plate
1. Open the throat plate slide ( page 13).
2. Loosen both screws (1).
3. Remove the throat plate (2).
Installing the throat plate
1. Insert the throat plate (2), ensuring that the nose (4) of the bobbin
2. Tighten both screws (1).
3. Close the throat plate slide ( page 13).
14
WARNING
Risk of injury.
Risk of crushing injuries and stab wounds from mov-
ing and sharp parts.
Switch the sewing machine off before you remove
or install the throat plate.
①
(1) - Screws
(2) - Throat plate
housing (3) is in the cutout of the throat plate.
(3) - Bobbin housing
(4) - Nose
Service manual 567 classic - 01.0 - 10/2015
Working basis
④
③
②