5
Correct setting
The 3 setscrews (3) on the arm shaft crank (1) are seated flush on the flat.
The arm shaft crank (1) is flush with the machine casting (2).
Cover
• Arm cover ( 3.3.2 Removing and fitting the arm cover, page 11)
Fig. 13: Setting the arm shaft crank
Setting steps
1. Release all the setscrews (3) on the arm shaft crank (1).
2. Turn the arm shaft crank (1) such that the setscrews (3) are seated flush
3. Push the arm shaft (1) to the right as far as it will go and flush with the
4. Tighten all the setscrews (3) on the arm shaft crank (1).
20
Positioning the arm shaft
WARNING
Risk of injury.
Crushing injuries from moving parts.
Switch the sewing machine off before you check
and set the position of the arm shaft crank.
①
②
③
(1) - Arm shaft crank
(2) - Machine casting
on the flat of the arm shaft.
machine casting.
Positioning the arm shaft
(3) - Setscrews
Service manual 567 classic - 01.0 - 10/2015