Setting The Feed-Dog Movement; Setting The Feed Movement - Dürkopp Adler 567 CLASSIC Service Manual

9.2 Setting the feed-dog movement

The feed-dog moves in an elliptical cycle. To align this correctly, both the
feed movement and the stroke height and stroke movement of the feed-
dog have to be set.
Order
First check the following setting:
• Feed-dog( 9.1 Setting the feed-dog position, page 27)

9.2.1 Setting the feed movement

The correct setting for the feed movement is checked at standstill and set
using the pusher eccentric.
Correct setting
Handwheel at the 190° position and set the stitch length adjusting wheel
to the maximum stitch length.
 If the drive is moved manually, the feed-dog stops.
Cover
• Tilt the upper section ( 3.3.1 Access to the machine bottom section,
Fig. 22: Setting the feed movement for the feed-dog
Setting steps
1. Set the stitch length adjusting wheel to the maximum stitch length.
2. Unscrew the setscrews (1).
3. Put the handwheel into the 190° position.
30
WARNING
Risk of injury.
Crushing injuries from moving parts.
Switch the sewing machine off before you check
and set the feed movement of the feed-dog.
page 10)
①
②
(1) - Setscrews
(2) - Pusher eccentric
Setting the feed-dog
(3) - Drive
Service manual 567 classic - 01.0 - 10/2015
③