Table of Contents
Advertisement
17 Feed dog
17.1 Setting the feed dog position in the throat plate cutout
Proper setting
The feed dog should be aligned so that it strikes no side of the throat plate
at the greatest possible stitch length.
Fig. 80: Setting the feed dog position in the throat plate cutout (1)
(1) - Screw
To set the feed dog position in the feed direction:
1. Tilt the machine head ( p. 19).
2. Loosen the screw (1) on the advance lever.
3. Place the feed dog at the appropriate position.
4. Tighten the screw (1) on the advance lever.
80
WARNING
Risk of injury!
Crushing, cutting and punctures are possible.
Only set the feed dog position in the throat plate
cutout when the machine is switched off.
①
Service Instructions 195 - 00.0 - 12/2017
Feed dog
Advertisement
Table of Contents
