Disassembling And Assembling The Feed Dog; Flats On Shafts - Dürkopp Adler 52Xi Service Instructions Manual

3.3.6
Pic. 6: Disassembling and assembling the feed dog
(1) - Feed dog
Disassembling the feed dog
1. Loosen the screws (2).
2. Remove the feed dog (1).
Assembling the feed dog
1. Insert the feed dog (1).
2. Tighten the screws (2).
Important
Check the feed dog settings ( p. 34).

3.4 Flats on shafts

Pic. 7: Flats on shafts
(1) - Flat
Some shafts have flat surfaces at the points where the components are
screwed on. This stabilizes the connection and makes setting easier.
The first screw in the direction of rotation is always screwed on to a flat
surface.
Important
Always ensure that the screws are completely flush with the surface.
16

Disassembling and assembling the feed dog

①
①
(2) - Screws
②
(2) - Shaft
Service Instructions 52Xi, 52Xi-75 - 03.0 - 09/2023
Working basis
②