Using Show Commands; Show Commands To Display Cisco Webex Node Spa Status; Show Commands To Display Cisco Webex Node Spa Idprom; Show Command To Display Cisco Webex Node Spa Service Engine Status - Cisco ASR 1000 Configuration Manual

General Troubleshooting Information
•
•
•

Using show Commands

There are several show commands, used in privileged EXEC mode, that you can use to monitor and
troubleshoot the Cisco WebEx Node SPA on Cisco ASR 1000 Series Routers. For more information on
these commands, refer to the Cisco IOS command references and see also the
Troubleshooting" section on page
the

show Commands to Display Cisco WebEx Node SPA Status

•
•
•
•

show Commands to Display Cisco WebEx Node SPA IDPROM

•
•
•

show Command to Display Cisco WebEx Node SPA Service Engine Status

The show hw-module subslot service-engine status command displays the operational status and
configuration of the Cisco WebEx Node SPA. For successful configuration of the service-engine
interface, the application status should be "Online." You can also confirm the provisioned operation
mode for the CiscoWex Node, which is "Web Conferencing" in the following example:
Router# show hw-module subslot 0/0 service-engine status
Service Engine is Cisco SPA-WMA-K9
Service Engine state: Steady (0x300)
Service Engine OS Version: 1.0.0, Application Version: 1.0.0
Application: WebEx Node (Web Conferencing)
Application Status: Online
Cisco ASR 1000 Series Aggregation Services Routers SIP and SPA Software Configuration Guide
23-2
Cisco WebEx Node SPA:
SPA_SE1
–
SPA_WMA
–
Cisco WebEx Node SPA Service Engine:
SPA_SRVCS_ENGINE
–
SPA_SRVCS_IF
–
SPA Online Insertion and Removal—SPA_OIR
"Configuring the Cisco WebEx Node for ASR 1000 Series"
show platform—Displays the status of all modules installed in the Cisco ASR 1000 Series Router
chassis. This command is not useful for out-of-service issues.
show hw-module subslot all oir—Displays the OIR status of each Cisco WebEx Node SPA in the
chassis. This command is useful for displaying out-of-service issues.
show hw-module subslot oir—Displays the OIR status for a specified Cisco WebEx Node SPA.
show hw-module subslot service-engine status—Displays the application and operational status
and configuration of a specified Cisco WebEx Node SPA.
show diag subslot eeprom—Displays main fields of the Cisco WebEx Node SPA IDPROM.
show diag subslot detail—Display all the fields of the Cisco WebEx Node SPA IDPROM.
show diag subslot dump—Dumps the content of the Cisco WebEx Node SPA IDPROM in
hexadecimal format.
Chapter 23 Troubleshooting the Cisco WebEx Node for the ASR 1000 Series
23-8, and the "Verifying the Service Engine Configuration" section of
"Performing Basic
chapter in this guide.
OL-14127-08