Tray 1 No Feeding: Late Jam : Cause Code 003 - Ricoh MP C3004 Field Service Manual

• Reconnect the connector.
• Replace the sensor.
• Replace the Paper Transport IOB.
• Replace the harness.
Target Part/SP No.: Duplex Exit Sensor / SP5-803-010
Execute an INPUT check when there is no paper at the position of the
referenced sensor.
Execute an INPUT check when there is paper at the position of the
referenced sensor.
Solution:
• Clean the sensor.
• Reconnect the connector.
• Replace the sensor.
• Replace the Paper Transport IOB.
• Replace the harness.
Jam
If the error occurs periodically, do the following steps. If the result is as shown in the "Problem
Judgement" column, follow the solutions.

Tray 1 No Feeding: Late Jam : Cause Code 003

Target Part/SP No.:Limit Sensor (1st Feed Tray) / SP5-803-014 (Tray 1: Upper Limit Sensor)
Execute an INPUT check when there is no paper at the position of the
referenced sensor.
Execute an INPUT check when there is paper at the position of the
referenced sensor.
Solution:
• Clean the sensor.
Cause verification
Cause verification
Troubleshooting for Transport/Paper Feeding of the Machine
Problem Judgement
0: Paper detected
1: Paper not detected
Problem Judgement
1: Limit
0: Not limit
1103