NEC UNIVERGE SV8100 Features & Specifications Manual page 628

Issue 5.0
Guide to Feature Programming
ISDN – BRI Installation
Program
Number
10-03-01
10-03-03
10-03-04
10-03-08
10-03-09
10-03-13
10-06-01
1 - 618
Program Name
ETU Setup (BRIA PKG) – ISDN
Line Mode
ETU Setup (BRIA PKG Setup) –
Connection Type
ETU Setup (BRIA PKG Setup) –
Layer 3 Timer Type
ETU Setup (BRIA PKG Setup) –
Dial Sending Mode
ETU Setup (BRIA PKG Setup) –
Dial Information Element
ETU Setup (PRTA PKG Setup) –
Loss of Signal Detection Limit
ISDN BRI Setup – TEI Selection
Description/Comments
Setup and confirm the Basic
Configuration data for each
CD-2BRIA. Use this program to
select the ISDN Line Mode.
Setup and confirm the Basic
Configuration data for each
CD-2BRIA. Confirm the
connection type for each
CD-2BRIA.
Setup and confirm the Basic
Configuration data for each
CD-PRTA
. This program selects
the Layer 3 timer type (1~5). Each
timer value of Layer 3 is set up for
each type in Program 81-06
(T-Bus).
ISDN protocol definition. Select
either enblock or overlap sending.
ISDN Protocol definition. If
Overlap Sending is selected in
Program 10-03-08, select either
Keypad Facility (0) or Called Party
Number (1) for the dial information
element.
If the transmit/receive voltage is
less than the setting in Program
10-03-13, the system considers
this as Loss-Of-Signal and the PRI
does not come up. Note that there
are different values based on the
setting in Program 10-03-12 for
the PRI.
Select the method the system
uses when assigning Terminal
Endpoint Identifier (TEI) values to
the BRI Circuit.
UNIVERGE SV8100
Assigned Data
0 = Not Used
1 = T-Point
(default = 1)
0 = Point-to-Multipoint
1 = Point-to-Point
(default = 0)
1~5
(default = 1)
0 = Enblock Sending
1 = Overlap Sending
(default = 1)
0 = Keypad Facility
1 = Called Party
Number
(default = 0)
0 = Level 0
(lowest sensitivity)
1 = Level 1
2 = Level 2
3 = Level 3
4 = Level 4
5 = Level 5
6 = Level 6
7 = Level 7
(highest sensitivity)
(default = 2)
0 = Select by SPID
number
1 = Select by Channel
ID Number
(default = 0)
ISDN Compatibility