NEC UNIVERGE SV8100 Features & Specifications Manual page 543

UNIVERGE SV8100
Guide to Feature Programming
Program
Number
10-42-01
10-42-02
10-42-03
10-42-04
10-42-05
10-42-05
10-42-06
11-07-01
16-02-01
Operation
Example
By default it is not possible to directly dial an Incoming Ring Group (IRG) but by configuring the Virtual
Loopback it is possible to dial a 'Pilot Number' for this purpose.
1. Enter required number of loopback ports
Easy Edit reference
o
Blades, Virtual Loopback Basic Setup, Virtual Loopback Basic Setup
o
2. 2. Make a note of automatically configured trunk and extensions ports (e.g. trunk = 01, extn = 08)
3. 3.Enter the virtual loopback extension ports into a free department group e.g. 10
Flexible Transfer/Virtual Loopback
Program Name
Loopback Port Count
Logical Trunk Port
Logical Telephone Port
Layer 3 Timer Type
Calling Party Number
Announcement
S-Point DDI Digits
S-Point Call Busy Mode
Department Group Pilot
Numbers
Department Group Assignment
for Extensions.
Description/Comments
Assign the number of virtual
loopback ports required.
Displays the starting port for the
virtual loopback trunks. View only.
Displays the starting port for the
virtual loopbackextensions. View
only.
Specified the layer 3 timer for
virtual loopback
Specifies whether the CPN is
announced
Specifies the amount of digits
dialled in addition to the virtual
loopback extension numbers.
Specifies whether an alerting or
disconnect message is sent when
a call is made to a busy port
Assign a pilot number to the
department group assigned to the
virtual loopback extension ports
Assign the loopback extension
ports to an unused department
group
Issue 5.0
Assigned Data
(default not assigned)
(default not assigned)
(default not assigned)
default = 1
Default enabled
Default none
default alerting
defaulkt = 1
Default =1
1 - 533