NEC UNIVERGE SV8100 Features & Specifications Manual page 984

Issue 5.0
Method B – Tandem Trunking with Transfer Key
Program
Number
14-01-04
14-01-05
14-01-13
15-07-01
20-06-01
20-07-11
20-11-14
20-11-21
20-13-10
1 - 974
Program Name
Basic Trunk Data Setup –
Transmit Gain Level for
Conference and Transfer Calls
Basic Trunk Data Setup –
Receive Gain Level for
Conference and Transfer Calls
Basic Trunk Data Setup –
Trunk-to-Trunk Transfer
Programmable Function Keys
Class of Service for Extensions
Class of Service Options
(Administrator Level) – Forced
Trunk Disconnect (analog trunk
only)
Class of Service Options (Hold/
Transfer Service) –
Trunk-to-Trunk Transfer
Restriction
Class of Service Options (Hold/
Transfer Service) – Restriction
for Tandem Trunking on Hang Up
Class of Service Options
(Supplementary Service) –
Barge-In Monitor
Description/Comments
Select the Transmit CODEC gain
level used by the trunk when it is
part of an Unsupervised
Conference.
Select the Receive CODEC gain
level used by the trunk when it is
part of an Unsupervised
Conference.
For each trunk, enter 1 to enable
loop supervision.
Assign a function key for Transfer
(code 06).
Assign a Class of Service (1~15)
to an extension.
Turns Off (0) or On (1) an
extension to use Forced Trunk
Disconnect. This allows the
extension to disconnect an
Unsupervised Conference in
progress.
Turns Off (0) or On (1) the
Trunk-to-Trunk Transfer
Restriction. If enabled,
Trunk-to-Trunk Transfer is not
possible.
Deny (1) an extension user's
ability to set up a tandem call
automatically when they hang up.
Enables the extension Barge-In
Mode to be speech mode (0) or
Monitor mode (1).
Tandem Trunking (Unsupervised Conference)
UNIVERGE SV8100
Assigned Data
1~63(-15.5dB ~
+15.5dB in 0.5dB
intervals)
[default = 32 (0dB)]
1~63(-15.5dB ~
+15.5dB in 0.5dB
intervals)
[default = 16 (-8dB)]
0 = Disable
1 = Enable
(default = 1)
Line Key 1~48
0~99 (Normal Function
Code 851 by default)
* *
00 ~ 99
(Appearance Function
Code) (Service Code
852 by default)
Day Night/Mode: 1~8
Class of Service of
Extensions (1~15)
Default:
All extension port =
Class 1
0 = Off
1 = On
(default = 0 for
COS 1~15)
0 = Off
1 = On
(default = 0 for
COS 1~15)
0 = Off
1 = On
(default = 0 for
COS 1~15)
0 = Off
1 = On
(default = 0 for
COS 1~15)