NEC UNIVERGE SV8100 Features & Specifications Manual page 573

UNIVERGE SV8100
Guide to Feature Programming
Program
Number
11-11-62
15-02-41
15-02-42
15-02-43
15-07-01
20-02-05
20-02-12
Headset Operation
Program Name
Service Code Setup (for Setup/
Entry Operation) – Headset Ring
Volume Adjustment
Multiline Telephone Basic Data
Setup – Incoming Ring Setup
Multiline Telephone Basic Data
Setup – Incoming Off-Hook Ring
Setup
Multiline Telephone Basic Data
Setup – Headset Ring Duration
Programmable Function Keys
System Options for Multiline
Telephones – Headset Busy
Mode
System Options for Multiline
Telephones – Forced Intercom
Ring (ICM Call Type)
Description/Comments
If needed, change the service
code used to adjust the Headset
Ring Volume.
Determine if incoming calls ring
the speaker or headset.
Determine if incoming off-hook
ringing rings the speaker or the
headset.
If incoming ringing is set for
headset, set the duration the call
rings the headset before ringing
the speaker.
Assign a function key for Headset
Operation (code 05).
Set the conditions under which a
headset extension is busy to
incoming callers:
The Headset extension is busy
to incoming callers when only
one extension appearance is
busy (0).
- OR -
Headset extension is busy to
incoming callers only when
both extension appearances
are busy (1).
Determine whether intercom calls
should ring or voice-announce
extensions.
Issue 5.0
Assigned Data
MLT
(default = 874)
0 = Speaker Normal
Ring
1 = Headset Ring
(default = 0)
0 = Speaker Off-Hook
Ring
1 = Headset Off-Hook
Ring
(default = 0)
0 = No Switch to
Speaker Ring
1 = 10 seconds
2 = 20 seconds
3 = 30 seconds
4 = 40 seconds
5 = 50 seconds
6 = 1 minute
(default = 0)
Line Key 1~48
0~99 (Normal Function
Code 851 by default)
* *
00 ~ 99
(Appearance Function
Code) (Service Code
852 by default)
0 = No
1 = Yes
(default = 0)
0 = Disable (Voice)
1 = Enable (Signal)
(default = 0)
1 - 563