Table 1-12 Incoming Ringing Tone - NEC UNIVERGE SV8100 Features & Specifications Manual

Issue 5.0
Program
Number
20-17-01
20-18-01
21-01-02
82-01-01
(01)
82-01-02
82-01-03
Handsfree Answerback/Forced Intercom Ringing:
Program
Number
20-02-12
20-06-01
1 - 606
Program Name
Operator Extension – Operator's
Extension Number
Service Tone Timers – Extension
Dial Tone Time
System Options for Outgoing
Calls – Intercom Interdigit Time
Incoming Ring Tone – Frequency
1
Incoming Ring Tone – Frequency
2
Incoming Ring Tone –
Modulation
Program Name
System Options for Multiline
Telephones – Forced Intercom
Ring (ICM Call Type)
Class of Service for Extensions
Description/Comments
Define the extension numbers
which are to be used by operators.
After getting Intercom dial tone, a
multiline terminal user has this
time to dial the first digit of the
Intercom call.
When placing Intercom calls,
users must dial each digit within
this time.
Customize the Intercom ring tone.
Customize the Intercom ring tone.
Use this program to customize the
Intercom Ring Tone modulation if
desired.
Description/Comments
Determine if an extension ICM
calls should be set as Forced
Intercom Ringing (1). If disabled
(0), Intercom calls
voice-announce. For all NEC
Cordless telephones, this option
must be set to "1" as voice
announce is not possible.
Assign Class of Service (1~15) for
extensions.
UNIVERGE SV8100
Assigned Data
Up to eight digits
(default = 101)
0~64800 (seconds)
(default = 30 seconds)
0~64800 (seconds)
(default = 10 seconds)
1 = 520Hz
2 = 540Hz
3 = 660Hz
4 = 760Hz
5 = 1100Hz
6 = 1400Hz
7 = 2000Hz
Default:
Refer to Table 1-12
Incoming Ringing Tone
on page 1-607
0 = No Modulation
1 = 8Hz Modulation
2 = 16Hz Modulation
3 = Envelope
(default = 2)
Assigned Data
0 = Disable (Voice)
1 = Enable (Signal)
(default = 0)
Day Night/Mode: 1~8
Class of Service of
Extensions (1~15)
Default:
All extension port =
Class 1
Intercom