Siemens SITRANS P DS III Operating Instructions Manual page 83

Parameter
The following tables give the meaning of the variables, depending on the value of the
"transmitter type" parameter. This allows you to select the units available in mode 14.
Table 6- 5
Source of measured value display
From analog input function block:
[0] : Output :
From pressure transducer block:
[1] : Secondary variable 1
[2] : Measurement value (primary
variable)
[3] : Sensor temperature
[4] : Electronics temperature
[7] : Raw pressure value
Table 6- 6
Source of measured value display
From analog input function block:
[0] : Output
From pressure transducer block:
[1] : Secondary variable 1
[2] : Measurement value (primary
variable)
[3] : Sensor temperature
[4] : Electronics temperature
[5] : Secondary variable 3:
[7] : Raw pressure value
From totalizer function block:
[6] : Totalizer output
*) The option of selecting the physical unit is additionally determined by the channel setting (mass or
volume) of the analog input and totalizer function blocks.
SITRANS P DS III/P410 with PROFIBUS PA
Operating Instructions, 02/2016, A5E00053276-08
Measurement type "Absolute pressure", "Differential pressure" and "Pressure"
Measurement type "Flow"
Variable Available unit
OUT (P) Pressure
(U) User specific
SEC 1 (P) Pressure
PRIM (P) Pressure
TMP S (T) Temperature
TMP E (T) Temperature
SENS (P) Pressure
Variable Available unit
OUT (L) Level
(U) User specific
SEC 1 (P) Pressure
PRIM (L) Level
TMP S (T) Temperature
TMP E (T) Temperature
SEC 3 (M) Mass flow
SENS (P) Pressure
TOTAL (V) Volume
(ΣM) *) Total mass flow
Flow not relevant for relative and ab-
solute pressure
Operation
6.5 Local operation
83