Introduction; Purpose Of This Documentation; Product Information; History - Siemens SITRANS P DS III Operating Instructions Manual

Introduction

1.1

Purpose of this documentation

These instructions contain all information required to commission and use the device. Read
the instructions carefully prior to installation and commissioning. In order to use the device
correctly, first review its principle of operation.
The instructions are aimed at persons mechanically installing the device, connecting it
electronically, configuring the parameters and commissioning it, as well as service and
maintenance engineers.
1.2

Product information

The programming manual is an integral part of the CD, which is either supplied or can be
ordered. The programming manual is also available on the Siemens homepage.
On the CD, you will also find the catalog extract with the ordering data, the Software Device
Install for SIMATIC PDM for additional installation, and the required software.
See also
Process instrumentation catalog (http://www.siemens.com/processinstrumentation/catalogs)
Product information on SITRANS P in the Internet (http://www.siemens.com/sitransp)
1.3

History

This history establishes the correlation between the current documentation and the valid
firmware of the device.
The documentation of this edition applies to the following firmware:
Edition
12/2015
SITRANS P DS III/P410 with PROFIBUS PA
Operating Instructions, 02/2016, A5E00053276-08
Firmware identifier nameplate
FW:300.01.08
FW:301.01.10
PROFIsafe
FW:301.02.03
FW:301.02.04
System integration
SIMATIC PDM V8.x
1
11