Rotating The Display - Siemens SITRANS P DS III Operating Instructions Manual

Procedure
NOTICE
Damage to the ribbon cable
If the pressure transmitter enclosure is rotated against the measuring cell, this can damage
the ribbon cable (sensor connection to the electronics).
• Comply with the specified range of rotation
1. Loosen the retaining screw
2. Turn the electronic housing against the measuring cell. Follow the marked turning range
①
3. Tighten the retaining screw (torque: 3.4 to 3.6 Nm).
4.7

Rotating the display

You can rotate the display in the electronics enclosure. This makes it easier to read the
display if the device is not being operated in a vertical position.
Procedure
1. Unscrew the cover of the electrical cable compartment. See section Structure (Page 24).
An identification text "FIELD TERMINAL" is provided at the side of the housing.
2. Unscrew the display. Depending on the application position of the pressure transmitter,
you can reinstall it at four different positions. You can turn it by ±90° or ±180°.
3. Screw the covers back on as far as they will go.
4. Secure the covers with the cover catch.
SITRANS P DS III/P410 with PROFIBUS PA
Operating Instructions, 02/2016, A5E00053276-08
while doing so.
①
as detailed.
②
(Allen screw 2.5 mm).
Installing / mounting
4.7 Rotating the display
61