Connecting up
5.3 Connecting the M12 connector
4. Tighten the screws in the key cover.
5. Check the tightness of the blanking plugs
degree of protection.
①
Key cover
②
Cable gland
③
Safety catch (back)
④
Cover (rear) for electrical terminal compartment
Image 5-2
View of the pressure transmitter: Left: Back right: Front view
See also
Structure (Page 24)
5.3
Connecting the M12 connector
Procedure
A conductive connection must not exist between the shield and the connector housing.
The connector may only be used for Ex ia devices and non-Ex devices; otherwise the
safety required for the approval is not guaranteed.
68
CAUTION
WARNING
⑤
and cable gland
⑤
Blanking plug
⑥
Safety catch (front)
⑦
Cover (front), optionally with inspection window
⑧
Safety catch for stainless steel enclosure
SITRANS P DS III/P410 with PROFIBUS PA
Operating Instructions, 02/2016, A5E00053276-08
②
in accordance with the