Operation Using Buttons; Setting/Adjusting Electrical Damping - Siemens SITRANS P DS III Operating Instructions Manual

1) Mode 7 is not available with transmitter for absolute pressure. Please note the information
in the sections "" and "".LO calibration (Page 91)HI calibration (Page 92)
6.5.2

Operation using buttons

Introduction
This overview informs you about the most important safety notes to be observed when
operating the pressure transmitter. Furthermore, the overview guides you in adjusting the
operating functions on site.
Requirement
The keyboard must have been unlocked in order to operate the device using the buttons.
Procedure
In the default setting, the device is in the measured value display.
To adjust the operating functions, proceed as follows:
1. Loosen both the screws of the keyboard cover and lift it upwards.
2. Press the [M] button until the desired mode is displayed.
3. Keep pressing the [↑] or [↓] button until the desired value is displayed.
4. Press the [M] button.
Now you have saved the values and the device goes to the next mode.
5. Close the keyboard cover using the two screws.
Note
If you allow more than 2 minutes to pass after pressing a button, the setting is saved and
the measured value display is returned to automatically.
6.5.3

Setting/adjusting electrical damping

Difference between setting and adjusting
You can set or adjust the time constant of electrical damping using the buttons. Setting
means that the time constant is automatically set to 0 seconds. Adjusting means that the
time constant is adjusted between 0 and 100 seconds using the increments of 0.1 seconds.
This electrical damping also has an effect on the built-in basic damping of the device.
SITRANS P DS III/P410 with PROFIBUS PA
Operating Instructions, 02/2016, A5E00053276-08
Operation
6.5 Local operation
79