Set Up And Operation; How Do I Connect My Ct400/410 Printer To My Computer; How Do I Install The Carbon Ribbon; How Do I Install The Labels - SATO CT400 Frequently Asked Questions Manual

CT400/410 FAQs
2.

Set Up and Operation

How do I connect my CT400/410 printer to my computer?

Connect the main unit with the AC adaptor using the power cable.
Remember to place the stopper firmly into the main unit twisting it
in a clockwise direction. The SATO CT400/410 model has an IEEE
1284 parallel interface, however options include Serial RS232C,
IEE 1284, USB and Ethernet LAN.

How do I install the carbon ribbon?

The CT400/410 carbon ribbon must be installed face-out. The core
with the new carbon ribbon is positioned at the back and is then
wound onto the empty core positioned in front of it. When installing
the carbon ribbon on to the spindles please ensure that the ribbon
sits up against the right side of the spindle and that the carbon rib-
bon runs under the print head and between the ribbon roller.

How do I install the labels?

The labels must be wound face-in and placed in the media tray,
which is centre-adjusted. Make sure that the labels pass under the
print head and fall under the sensor.

How do I feed a blank label?

While the printer is offline, press the FEED button. If you have prob-
lems check that the print media is loaded correctly.

Does the CT400/410 have a last label repeat feature?

Yes. Pressing the feed button in online mode reprints the last label.

How can I cancel my print job?

The current print job can be cancelled by turning the printer off and
on, or by using the software to send a command to delete the cur-
rent print job.
TOC
SATO EUROPE
3