Adf Unit Assembly Removal (Models X651, X652, X654, And X656) - Lexmark 7462 series Service Manual

ADF unit assembly removal (models X651, X652, X654, and X656)

Notes:
•
Use part number 40X2738 for the X651 and X652 models.
•
Use part number 40X6395 for the X654 and X656 models.
1
Remove the scanner rear cover. Go to
2
Remove the scanner left cover. Go to
on page 522.
Note: Models X651 and X652 do not need the scanner left cover removed (no duplex ADF cable).
3
Slide the left scanner cover to the rear, and remove.
4
Disconnect the CCD harness and ground strap from behind the left side scanner cover.
5
Disconnect the CCD harness and ground strap from behind the rear scanner cover.
6
Open the ADF.
7
Remove the two thumb screws (A) on either side of the ADF unit.
8
Slide the ADF unit to the rear, lift up, and remove the ADF unit assembly.
Installation note: When reinstalling the ADF unit assembly, make sure to adjust the skew. Go to
skew" on page 291.
"Scanner rear cover removal" on page
"Scanner left cover removal (models X651, X652, X654, and X656)"
Repair information
560
522.
A
7462
"Adjusting