Lexmark 7462 series Service Manual page 153

Error code Description
28y.59 The sensor (self priming) within the stapler
assembly does not detect a ready staple in the
specified time after the staple job was sent.
28y.60 A software error has occurred with the output
option. The status of the stapler motor is not
defined.
28y.61 A software error has occurred with the output
option. DMID command is not received for 500ms
after main motor runs.
28y.62 A software error has occurred with the output
option.
When the finishing job is not completed yet, the first
DMID command of the next job is received.
28y.63 A software error has occurred with the output
option (bin clamp motor control timer error).
28y.64 A software error has occurred with the output
option (bin clamp motor control timer error during
tray holder initial).
28y.65 The bin clamp home position is not detected by the
sensor (bin clamp HP).
28y.66 The sensor (bin clamp HP) does not detect that the
bin clamp has moved from home position.
28y.67 A software error has occurred with the output
option (invalid bin clamp manager state).
28y.68 The sensor (self priming) within the stapler
assembly does not detect a ready staple prior to a
staple job.
28y.69 The sensor (self priming) within the stapler
assembly does not detect a ready staple in the
specified time after the staple job was sent.
28y.70 The sensor (home signal) within the stapler
assembly detected that the stapler mechanism was
not in the home position before stapling.
28y.71 The sensor (deflector gate HP) does not detect
transition of the deflector gate to the standard bin.
28y.72 Media remains on the sensor (media in stapler)
during warm up sequence.
Action
Go to
check" on page
Go to
service check" on page
Go to
service check" on page
Go to
service check" on page
Go to
service check" on page
Go to
service check" on page
Go to
check" on page
Go to
check" on page
Go to
service check" on page
Go to
check" on page
Go to
failure service check" on page
Go to
not detected service check" on page
Go to
stapler) service check" on page
Diagnostic information
153
"Staple ready home position jam service
158.
"StapleSmart finisher software error
154.
"StapleSmart finisher software error
154.
"StapleSmart finisher software error
154.
"StapleSmart finisher software error
154.
"StapleSmart finisher software error
154.
"StapleSmart finisher bin clamp service
155.
"StapleSmart finisher bin clamp service
155.
"StapleSmart finisher software error
154.
"Staple ready home position jam service
158.
"Stapler mechanism not in home position
"Deflector gate transition to standard bin
"Sensor (MFP stapler assembly media in
7462
162.
163.
155.