Lexmark 7462 series Service Manual page 273

To view the page count, from the Diagnostics menu, select PRINTER SETUP > Printed Page Count.
Permanent Page Count
Note: The Permanent Page Count value cannot be reset.
The value of this setting indicates the total amount of pages that have been printed. After all print tests have
been completed, the value will reset to zero.
1
From the Diagnostics menu, select PRINTER SETUP.
2
Depending on your printer model, select Perm Setup Page or Permanent Setup Page.
Serial Number
Note: The value of the setting can only be viewed.
1
From the Diagnostics menu, navigate to PRINTER SETUP > Serial Number.
2
Depending on your printer model, touch Back or press the Back button to return to PRINTER SETUP.
Engine Setting [x]
Warning—Potential Damage: Do not change these settings unless requested to do so by your next level of
support.
These settings are used by Engine code ECs to fix field problems. [x] represents any value from 1 to 16.
Model Name
The model name can only be viewed and cannot be changed.
Configuration ID
There are two configuration IDs that are used to communicate information about certain areas of the printer
that cannot be determined using hardware sensors. The IDs are originally set at the factory when the printer is
manufactured. However, you may need to reset Configuration ID 1 or Configuration ID 2 whenever you replace
the system board. The IDs consist of eight hexadecimal characters, including 0 through 9 and A through F.
When the printer detects a Configuration ID that is not defined or invalid:
•
The default standard model configuration ID is used instead.
•
The configuration ID becomes the only function available in DIAGNOSTICS.
Check Config ID appears on the display except when the menu is in DIAGNOSTICS.
•
1
From the Diagnostics menu, navigate to PRINTER SETUP > Configuration ID.
Note: Submitting Selection and the value for Configuration ID 1 appear on the display
2
Enter configuration ID 1.
•
Use the left or right arrow button to select a digit or character. Wait until the digit or character is
underlined.
•
Use the up or down arrow button to change a digit or character.
Service menus
273
7462