Bin Mailbox Assembly Sensor (Mailbox Empty) Removal - Lexmark 7462 series Service Manual

4
Disconnect the sensor (pass through) harness from the controller board.

4-bin mailbox assembly sensor (mailbox empty) removal

Note: The sensor (pass through) is the lower rear sensor. The rear upper sensor is the sensor (mailbox
empty).
1
Open the rear door.
2
Life the deflector gate above the sensor (mailbox empty) and using a flat‑blade screwdriver, release the tabs
securing the sensor (mailbox empty) to the 4‑bin mailbox assembly.
Repair information
398
7462