Adf Unit Assembly Removal (Models X651, X652, X654 And X656) - Lexmark X651de Service Manual

ADF unit assembly removal (models X651, X652, X654 and X656)

1. Remove the scanner cover, rear. See
and X658)" on page
2. Remove the scanner cover, left. See
X656)" on page
Note: Models X651and X652 do not need the left scanner cover removed (no duplex ADF cable).
3. Slide the left scanner cover to the rear, and remove.
4. Disconnect the CCD harness and ground strap from behind the left side scanner cover.
5. Disconnect the CCD harness and ground strap from behind the rear scanner cover.
6. Open the ADF.
7. Remove the two thumb screws (A) on either side of the ADF unit.
8. Slide ADF unit to the rear, lift up, and remove the ADF unit assembly.
Replacement note: You must adjust skew after reinstalling the ADF unit assembly. Go to
on page 3-93.
ADF unit assembly removal (model X658)
1. Remove the scanner cover, rear. See
and X658)" on page
2. Remove the scanner support cover, left. See
page 4-144.
3. Disconnect the CCD harness and ground strap from behind the scanner support cover, left.
4. Disconnect the CCD harness and ground strap from behind the rear scanner cover.
5. Open the ADF.
"Scanner cover, rear removal (models X651, X652, X654, X656,
4-125.
"Scanner cover, left removal (models X651, X652, X654 and
4-126.
"Scanner cover, rear removal (models X651, X652, X654, X656,
4-125.
A
"Scanner support cover, left removal (model X658)" on
7462
"Adjusting skew"
4-83
Repair information