Operator Panel Door Assembly Removal (Models X651, X652, X654, And X656) - Lexmark T650 Service Manual

Operator panel door assembly removal (models X651, X652, X654, and X656)

Warning: When replacing any of the following components:
• Operator panel assembly
• System card assembly
Only replace one component at a time. Replace the required component and perform a POR before replacing a second
component listed above. If this procedure is not followed, the printer will be rendered inoperable. Never replace two or more
of the components listed above without a POR after installing each one or the printer will be rendered inoperable.
Never install and remove components listed above as a method of troubleshooting components. Once a component has
been installed in a machine, it can not be used in another machine. It must be returned to the manufacturer.
1. Remove the laser cover. See
page 4-105.
2. Remove the counter balance springs (A) on both sides.
3. Remove the print cartridge cover springs (B) on both sides.
4. Remove the E-clips (C) on both sides securing the links to the hinges, and remove the links.
5. Remove the pins (D) on both sides securing the links.
"Laser cover removal (models X651, X652, X654, and X656)" on
C
4062-XXX
D
A
B
Repair Information
4-49