How To Erase The Settings For A Profile; How To Restore Default Settings To A Profile - Furuno FMD-3200 Operator's Manual

1. INTRODUCTION
1.16.4

How to erase the settings for a profile

1. Click [ ] on the Status bar then click [Manage Profile].
2. Select a profile number from the "Profile" drop-down list.
3. Click [Clear Profile].
The confirmation message "This profile will be cleared. Do you wish to continue?"
appears.
4. Click [Yes] to clear all settings for the selected profile. Click [No] to cancel.
1.16.5

How to restore default settings to a profile

1. Click [ ] on the Status bar then click [Manage Profile].
2. Click [Default Settings].
The confirmation message "Settings will be changed to the default. Do you wish
to continue?" appears.
3. Click [Yes] to clear all settings for the selected profile. The settings on the follow-
ing table are changed to the recommended settings.
[Route Information] menu
Route information page
[System Sensor Settings]/[Local Sensor Settings] menu
SPD page
[Other Sensor Settings] menu
Other Sensor page
[Basic Setting] menu
Basic Setting page
[Chart Display] menu
General page
Text page
NtoM page
[Symbol Display] menu
General page
1-16
Item
unit of "XTD"
Stabilization Mode
Wind
TM Reset
Symbols
Boundaries
Four Shades
Full Light Lines
Scale MIN
Shallow Pattern
Shallow Water Dangers
Unknown
Accuracy
Highlight Date Dependent
Highlight INFO
Highlight Document
Contour Labels
LAT/LON Grid
Important Text
Temporary Notices
Preliminary Notices
No Information
Ship Outlines
AIS Outlines
Settings
m
Bottom
m/s
90%
Paper Chart
Plain
Unchecked
Unchecked
Checked
Unchecked
Checked
Checked
Unchecked
Unchecked
Unchecked
Unchecked
Unchecked
Unchecked
Checked
Unchecked
Unchecked
Unchecked
OFF
OFF (grayed out)