System Menu; Can Bus (Nmea2000) Network Shared Settings - Furuno FI70DSW Operator's Manual

4.

SYSTEM MENU

This chapter explains the various items in the [System] menu which have not been
explained yet. To open the [System] menu, do the following:
1. Press the Menu/Back key to display the main menu.
2. Press the software keys to select [System], then press the function key.
4.1

CAN bus (NMEA2000) Network Shared Settings

TZTL12F
OR
TZTL15F
The NMEA network may contain one, or several, FI-70 units as well as other
equipment. In the example above, the network contains a TZtouch2 unit and four
FI-70 units.
Some settings, such as data source and offsets, made on a TZtouch2 unit (or FI-70
set as a Master unit) within the network may be passed onto the sub units on the same
network. This requires adjustment of the [Sharing] setting on the FI-70 unit or units you
wish to share settings with. The following list shows the settings which may be shared
across the network.
• Display Format menu - [HDG/COG Ref], [Time Offset] and [Mag. Var. Value] only.
• Data Calibration menu - All settings, excluding [W Angle Response].
• Data Source menu - All settings, excluding tanks ([Tank1] to [Tank6]).
• Units menu - All settings.
Note: TZtouch2 units in the same network as the FI-70 are automatically assigned
[Master] level sharing. In this situation, [Master] is not selectable from the [Sharing]
menu.
System
Key Beep:
Panel Dimmer:
Sharing:
Group:
Ent
T
AWA
FI-70 FI-70
Prev Func Next Prev
OFF
8
Stand Alone
A
T T
AWA AWA
FI-70
Func Next Prev Func Next
T
AWA
FI-70
Prev Func Next
4-1