Furuno FMD-3200 Operator's Manual page 391

PILOT WATCH control: Set the amount of course deviation to allow in automatic
steering. An alert is generated at the Autopilot when the deviation is more than the val-
ue set.
RUDDER LIMIT control: Limit the rudder motion to the least necessary rudder angle
during AUTO steering.
Steering override units
FU Override Unit
Starting steering override:
1) Confirm that the Ready lamp in
the FU unit is ON.
2) Press the Override steering
switch to give the control of the
steering to this unit, by the Over-
ride steering knob. A beep
sounds intermittently then the se-
lected steering mode indicator
flashes.
Stopping steering override:
1) Push the ON/OFF switch to show
ON in the FU override unit or
push the RESET switch on the
Override reset unit in the steering
stand to return to the previous
steering mode.
2) If the steering mode was AUTO,
the heading at the time override
steering became active is set as
heading. Auto resume is disabled
if the steering mode was
RC/NAV. To restore the RC
mode, turn the mode selection
switch to another steering mode
then select the RC mode again.
Ready lamp
Servo loop
fail lamp
Buzzer
Ready lamp
Ready lamp
26. AUTOPILOT OPERATIONS
Override steering
knob
Override steering
switch
Dimmer knob
Override indicator
Override steering
reset switch
Dimmer kno
Dimmer knob
26-7