Table of Contents
Advertisement
3.
SYSTEM SETTINGS AFTER
INSTALLATION
After installing all equipments, set up the equipment as shown in this chapter.
The FCV-30 is shipped from the factory ready for connection to an XGA monitor. To connect
an SXGA monitor, contact a FURUNO agent or dealer.
System Setting
Do the system settings as follows.
1. Click System in the menu bar to open the system menu.
Output
1. Click Output in the system menu to show the OUTPUT dialog box.
2. To output the TLL data (when the "Maker Line" in the menu bar is clicked) to external
equipment via NMEA port, set TLL to ON.
3. To output the seabed data to external equipment via NMEA port, set Bottom
discrimination to ON.
Note that this function outputs bottom hardness/roughness in ten levels, however there
is currently no receiving device which handles this data.
4. To set NMEA version according to equipment connected, choose the version among 1.5,
2.0 and 3.0.
5. Click the OK or Apply button.
15
Advertisement
Table of Contents
