Suzuki DF100A Owner's Manual page 26

MANUAL TILTING
If you are unable to tilt the motor using the
"Power Trim and Tilt" because of an electrical
problem or some other problem, you can move
the motor manually. To tilt the motor up or
down, turn the manual release valve A two
turns counterclockwise, move the motor to the
desired position, then retighten the release
screw.
 CAUTION
The motor is very heavy. When you tilt it man-
ually, you could injure your back or slip and
fall causing injury.
When you tilt the motor manually, ensure that
your grip and footing are secure and that you
are able to support the weight of the engine.
TILT BRACKET
The Tilt Bracket is provided so you can support
the motor in a tilted position for non-moving
engine support.
To set the Tilt Bracket:
1. Tilt the motor all the way up using the Power
Trim and Tilt.
2. Pull down the Tilt Bracket as shown in the
illustration.
OPEN
CLOSE
3. Lower the motor using the Power Trim and
Tilt, until the motor is supported by the Tilt
Bracket.
 CAUTION
The remote Power Trim and Tilt switch will
work when the ignition switch is off. If some-
one activates the switch while you are moving
the tilt lever, your hand could be injured.
Keep all persons away from the remote Power
Trim and Tilt switch while you are moving the
tilt lever.
NOTICE
Damage can occur if you use the tilt lever
other than when the boat is moored or is oth-
erwise stationary.
The tilt lever relieves pressure from the power
trim and tilt and should only be used when the
boat is stationary. Do not use the tilt lever
when trailering your boat and motor. Refer to
the TRAILERING section of this manual.
23