Adjusting The Image Density - Ricoh G092 Service Manual

MACHINE INSTALLATION
6. The test printing starts shortly after.
NOTE: If you cannot complete the test print,
check if an error message appears on the panel display. For more
information about error messages, see Section 5 "Troubleshooting" in
the Operating Instructions Maintenance Guide and Section 4 in this
support documentation.
7. Press the "On Line" key. "Ready" appears on
the panel display.
8. Turn off the printer's power switch.
9. At this point in the installation, you may wish to check and ensure that the
firmware level is current. The firmware version is indicated on the top (third item
under "System Reference") on the Configuration page.
Refer to the "Firmware Update Procedure" located in Section 5 of this manual.
Update the firmware if necessary. After completing the firmware update return
to this section and continue.
10. Next press the "#" or "$" key to display the "Color Demo Page." Press the
Enter key. Check to ensure that this page appears as expected (all colors
present)

1.2.7 ADJUSTING THE IMAGE DENSITY

1. Press the "Menu" key. "Menu" appears on the
panel display.
2. Press the "#" or "$" key to display
"Maintenance," then press the Enter key.
3. Press the "#" or "$" key to display "Image
Density", then press the Enter key.
NOTE: The message appears on the panel
display.
G081/G092
Printing...
Ready
Menu:
Paper Input
Menu:
Maintenance
Maintenance:
Image Density
Image Density:
Prt. Test Sheet
1-14
G081I907.WMF
G081I901.WMF
G081I902.WMF
G081I908.WMF
G081I909.WMF
G081I910.WMF
SM