Ricoh G092 Service Manual page 272

PRINTER CONTROLLER SERVICE MODE
Bit Switch 1 (Japan only)
Bit
0 Key protect [0: Not activated, 1: Activated] DFU
1 (Not used.) DFU
2 (Not used.) DFU
3 (Not used.) DFU
4 (Not used.) DFU
5 (Not used.) DFU
6 (Not used.) DFU
7 Emulation print area (RPCS only). [0: Not printed, 1: Printed]DFU
Bit Switch 2
Bit
1 Overlap job mode (njob) [0: Not activated, 1: Activated] DFU
⇒
3 PDL Sniffing - See PUB(C)-051 for details. [0: Enabled, 1: Disabled]
Bit Switch 3
Not used
Bit Switch 4 (Japan only)
Bit
Background areas of simple graphics (RPDL, R16, R55, R98) [0: Not
0
painted, 1: Painted] DFU
1 Unknown 2-byte characters (R98) [0: Cleared, 1: Not cleared] DFU
Specifies portrait/landscape reset (R16) [0: Reset by the reset
2
command, 1: Not reset by the reset command] DFU
3 Changes line thickness adjustment mode [0: Mode 1, 1: Mode 2] DFU
Displays or not displays error messages No. 84 through DF (RPDL,
4
R16, R55, R98, GL/GL2). [0: Displays, 1: Not displays] DFU
Displays or not displays error messages No. E1 and higher (RPDL, R16,
5
R55, R98, GL/GL2). [0: Displays, 1: Not displays] DFU
6 Changes the tray setting (GL/GL2). [0: LP, 1: MFP] DFU
7 Changes the default tray. [0: LP (Tray 1), 1: MFP (System default)] DFU
G081/G092
Function
Function
Function
5-6
Rev. 10/2003
Default
0
0
0
0
0
0
0
0
Default
0
0
Default
0
0
0
0
0
0
0
0
SM