MACHINE INSTALLATION
6. When using DHCP with TCP/IP protocol, set network boot, as follows.
1) From within Network Setups press the "!"
or """ key to display to display "DHCP," and
then press the Enter key. In about two
seconds, the display returns to the "Network
Setup" setting screen.
NOTE: * shows the current setting.
Depending upon the firmware this setting may be located under
"Network Boot."
7. When all of the settings are done, press the
On Line key. "Ready" appears on the panel
display.
Print the configuration page to confirm the settings made. See 1.2.6 for printing
8.
the configuration page.
G081/G092
Network Setup:
#DHCP
Ready
1-20
G081I922.WMF
G081I901.WMF
SM