Printer Engine Service Mode; Service Mode Table ("2. Engine"); Sp1-Xxx (Feed) - Ricoh G092 Service Manual

5.3 PRINTER ENGINE SERVICE MODE

An asterisk (*) after the mode number means that this mode's value is stored in the
NVRAM. A numeral or pound symbol (#) means that this mode's value is stored in
the EEPROM. If you do a RAM reset, all these SP modes will be returned to their
factory settings.

5.3.1 SERVICE MODE TABLE ("2. ENGINE")

SP1-XXX (Feed)

Mode No.
1
(Class 1, 2, and 3)
001 [Lead Edge Reg.] Leading Edge Registration
# Process Speed
1 TOP 100
2 TOP 124
3 TOP 50
002 [S-to-S Reg.] Side-to-Side Registration
#
1 Paper Tray 1
2 By-pass Table
3 Paper Tray 2
4 Paper Tray 3
5 Duplex
003 [Paper Buckle] Paper Buckle
# (Process Speed, Tray)
1 100 Tray1
2 100 Bypass
3 100 Tray2
4 100 Tray3
5 100 Dpx
6 124 Tray1
7 124 Bypass
8 124 Tray2
9 124 Tray3
10 124 Dpx
11 50 Tray1
12 50 Bypass
13 50 Tray2
14 50 Tray3
15 50 Dpx
105 [Fusing Temp.] Fusing Temperature
# (Paper Type, Process Speed)
Paper Type → N: Normal, Thin OHP. Card Envelope Label Coated Paper
Japanese PostCard(DFU)
1 N 100
2 N 124
3 N 50
4 Thin 100
5 Thin 124
6 Thin 50
7 OHP
8 Card
9 Envelope
10 Coated Paper
SM
PRINTER ENGINE SERVICE MODE
Function / [ Setting ]
Adjusts the leading edge registration by changing the
registration clutch operation timing for each mode.
[ 0 ~ 60 / 30 / 2 line/step ]
Adjusts the side-to-side registration by changing the laser
main scan start position for each mode.
[ 0 ~ 30 / 15 / 2 pixel/step ]
Adjusts the amount of paper buckle at the registration
roller by changing the paper feed timing.
[ 0 ~ 10 / 5 / 1 mm/step ]
[ 0 ~ 10 / 5 / 1.24 mm/step ]
[ 0 ~ 10 / 5 / 1 mm/step ]
Adjusts the fusing belt temperature for the printing ready
condition. The fusing temperature is depended on the
paper type.
Ready temperature = (Fusing temperature +
Temperature specified in this SP mode.
o
[ 0 ~ 20 / 10 / 1 C/step ]
1-105-12, 13: DFU (used in Japan only)
5-11 G081/G092