Ricoh G092 Service Manual page 140

PRINTER ENGINE SERVICE MODE
Mode No.
5
(Class 1, 2, and 3)
401* [ULimitAutoSet] User Limited Auto Set
14 ULimitAutoSet
404 [UCodeCtrClr] Use Code Counter Clear
UcodeCtrClr
801 [Memory Clear]
1 All
2 Engine Setting
3 SCS (System Control
Service)
4 IMH (Image Memory
Handler)
5 MCS (Memory Control
Service)
8 PRT
11 NCS
803 [Input Check]
804 [Output Check]
808 [Destination] Destination Code Display
1 Destination
811 [Serial Number] Serial Number Display
2 DispCntl SN (Display
Controller Serial
Number)
3 DisEng SN (Display
Engine Serial Number)
4 SetEng SN (Set
# Engine Serial Number)
812* [FAX TEL No.]
2 FAX TEL No.
G081/G092
Function / [ Setting ]
Activates the auto user code registration function (prints
are counted and logged for each user code and the
counts can be viewed with SmartNetMonitor).
[0 ~ 1 / 1 / 1/step]0: Inactivated
• 1: Activated
Clear all counters for users.
[0 ~ 0 / 0 / 0/step]
Clears the settings from the NVRAM and initializes the
settings.
[0 ~ 0 / 0 / 0/step]
Clears all the engine settings and counters.
Engine settings and engine counters can be cleared
independently with SP5-998-001 and 002.
[0 ~ 0 / 0 / 0/step]
Clears the system settings.
[0 ~ 0 / 0 / 0/step]
Clears IMH data. DFU
[0 ~ 0 / 0 / 0/step]
Clears MCS data. DFU
[0 ~ 0 / 0 / 0/step]
• MCS is for network settings.
Clears the user tool settings.
[0 ~ 0 / 0 / 0/step]
Clears the network settings.
[0 ~ 0 / 0 / 0/step]
See section 5.3.2.
See section 5.3.3.
Displays the destination code.
[ 0 = JP, 1 = NA, 2 = EU, 3 = AS ]
Display the machine serial number
Display the mechanical engine serial number
Set the mechanical engine serial number when the
EEPROM on the engine control board is replaced.
Sets the fax or telephone number for a service
representative by using the enter key and the down
arrow key.
[0 ~ 0 / 0 / 0/step]
Both numbers and alphabetic characters can be input.
5-16 SM