Ricoh G092 Service Manual page 43

4. Press the Enter key. When the message
appears on the panel display, press the Enter
key.
NOTE: The test printing will start shortly after.
5. Compare the colors on the printed image density test sheet with those on the
Image Density Adjusting Card.
6. Press the "#" or "$" key to select the color
you want to adjust, then press the Enter key.
7. Press the "#" or "$" key to set the image
density value, and press the Enter key. To
adjust another color, repeat steps 6 and 7.
NOTE: 1) You can adjust the image density from -10 to +10. Increasing the
value darkens the printouts and decreasing the value lightens the
printouts.
2) Pressing the "#" or "$" key increases or decreases the value by
one.
8. Print another image density test sheet and check if the colors on the test sheet
now mach those on the Image Density Adjusting Card. If they still do not match,
adjust the image density again.
9. Press the On Line key. "Ready" appears on
the panel display.
10. At this point in the installation turn to section
1.3 "Optional Unit Installation" in this manual.
Perform any option installation necessary then return to this section and
continue to section 1.2.8 "Connecting the Printer to a Computer" found on the
following page.
SM
MACHINE INSTALLATION
Prt. Test Sheet
Press # to Start
Printing...
Image Density:
Black
Black:
(-10 +10)
Ready
1-15
G081I911.WMF
G081I907.WMF
G081I912.WMF
0
G081I913.WMF
G081I901.WMF
G081/G092