Ricoh G092 Service Manual page 121

Sensor Name/
No.
Sensor Board Name
Waste Toner Detection
26
Sensor
Right Side Color
27
Registration Sensor
Paper Size Size 1
28
Switch
Paper Size Size 2
29
Switch
Paper Cassette
30
Detection Switch
31 Temperature Sensor
32 Humidity Sensor
Front Door/Right
33 Cover Open Sensor
(interlock switch)
34 ADU Detection Sensor
ADU Jam Detection
35
Sensor
36 Paper Jam Sensor
37 Paper Empty Sensor
Option Cassette Paper
38
Size 1 Switch
Option Cassette Paper
39
Size 2 Switch
Option Cassette
40
Detection Switch
NOTE: The "Active" column refers to the voltage-state present when the device
(sensor, switch, etc...) is performing its intended function.
For example: item 3 – Front/Right Door Open Detection Switch – Active H.
This indicates that when the Right Door is Open this device is active and
the voltage state at CN7/1 will be "High," in this case 5 volts dc.
If you require the "Ready" condition values refer to the G081/G092
Connector Layout Tables located on the back of your Point-to-Point.
SM
ELECTRICAL COMPONENT DEFECTS
Signal Name Active
WTB_NON H
SNS_R L
STPSZ1 L
STPSZ2 L
STNON H
TEMP Analog
HUM Analog
H
+5VLD
H
ADUNON
NADUJAM L
ACFJAM H
ACFPNON H
STPSZ1 L
STPSZ2 L
STNON H
4-17
CN No./
Pin No. Position
(Switch)
CN27/6
CN27/8
CN28/1
Rear side of Chassis
CN28/2
(paper size detector)
CN28/4
CN29/1 Humidity/Temperature
Sensor Board at left
CN29/3
side of Chassis
Right side of Chassis
CN35/1
(front)
CN39/2
Inner Cover (at Front
side of Chassis)
CN39/5
CN3201/2
CN3201/3
SW1
Option Feeder
SW2
SW3
G081/G092