Ricoh G092 Service Manual page 141

5 Mode No.
(Class 1, 2, and 3)
828* [Network] Job spool settings/ Interface selection for Ethernet and wireless LAN
66 HD Job Clear
67 Job Spool (LPR)
68 Job Spool (IPP)
71 Primary I/F
72 Current I/F
832 [HDD Init] HDD Initialization
1 HDD Init.
833 [Job log ON/OFF]
1 Job log ON/OFF
839 [IEEE1394]
7 Cycle Master
8 BCR mode
9 IRM 1394a Check
10 Unique ID
11 Logout
12 Login
13 Login MAX
840 [IEEE802.11b]
6 Channel Max
SM
PRINTER ENGINE SERVICE MODE
Function / [ Setting ]
Treatment of the job when a spooled job exists at power
on.
0: Data is cleared
1: Automatically printed
Job spool on/off (LPR).
0: Job spool off
1: Job spool on
Job spool on/off (IPP).
0: Job spool off
1: Job spool on
Interface selection for the Ethernet or wireless LAN when
both interfaces are available.
0: Ethernet
1: IEEE802.11b (wireless LAN)
Note: This setting is same as the user mode setting
"LAN Type" in the Network Setup of the Host Interface
menu.
Displays the current interface setting (Ethernet or
wireless LAN).
Initializes the hard disk.
[0 ~ 0 / 0 / 0 /step]
Use this SP mode only for hard disk error recover y.
Saves the result of the jobs in the job log. If this mode is
enabled, the result is written on the HDD. If no HDD is
installed, this feature is disabled even if this SP is set to
"enabled."
[0 or 1 / 0 / - ]
0: Disabled
1: Enabled
DFU
DFU
DFU
DFU
DFU
DFU
DFU
Sets the maximum value for the wireless LAN channel
adjustment. DFU
[1 ~ 11 or 13 / 1 / 1 /step]
Europe/Asia: 1 to 13
USA: 1 to 11
Note: Do not change the setting, or the machine may be
out of compliance with local regulations.
5-17 G081/G092