Ricoh G092 Service Manual page 32

MACHINE INSTALLATION
3. Lift the inner cover [A] until it stays up.
4. Remove the black photoconductor unit from its
packing materials.
5. Peel off the tape surrounding the
photoconductor unit, and remove the
top cover [B] on the unit.
NOTE: Do not remove the cover
attached to the bottom of the
photoconductor unit at this
time.
NOTE: After taking the new
photoconductor unit out of the bag,
immediately install it. Do not expose it to
ambient light for prolonged periods.
NOTE: Before proceeding with the
actual installation of the
development units, observe
the locations for each
photoconductor unit as shown
in this illustration.
when ready, continue to step 6
on the following page.
!
Photoconductor unit (black)
"
Photoconductor unit (color)
G081/G092
[A]
1-4
G081I311.WMF
[B]
G081I680.WMF
2 1
G081I720.WMF
SM