Ricoh G092 Service Manual page 47

4) Press the "!" or """ key to display "Active,"
and then press the Enter key. In about two
seconds, the display returns to the "Active
Protocol" setting screen.
NOTE:
* shows the current setting.
5) Set the rest of the protocols for use.
6) When all settings for the protocol are done, press the Escape key. The "Network
Setup" setting screen appears.
NOTE: 1)
The default settings for all of the protocols are "Active."
2)
It is recommended to set all the unused protocols to "Not Active."
4. Set the IP address for the printer.
NOTE: Check the IP address with the network
administrator.
1) Press the "!" or """ key to display "IP
Address," and then press the Enter key. The
currently selected IP address appears.
NOTE: 1)
When the Enter key is pressed, the cursor moves to the next field.
2)
When the "!"
changes by 10.
3) If DHCP is assigned the IP address can not be changed. Turn
DHCP off, then assign IP address.
2) Press the "!" or """ key to set the value for
the field.
3) Press the Enter key. The cursor moves to the next field.
4) Repeat 2) and 3) to set the value for the rest of the fields.
Set "Subnet Mask" and "Gateway Address" by following the same procedure as
5.
for setting the IP address
NOTE: 1)
Check the subnet mask value with the network administrator.
2)
The gateway address is the address of the host or router that acts as a
gateway when interacting with work stations in another network. Check the
value with the network administrator.
3)
If you are not sure of the addresses, do not set them.
SM
or
""" key is kept pressed for a few seconds, the value
.
1-19
MACHINE INSTALLATION
TCP/IP:
#Active
G081I918.WMF
Network Setup:
IP Address
G081I919.WMF
IP Address:
199.022.033.044
G081I920.WMF
G081/G092