Controller/Engine Firmware Upgrade; Engine Firmware - Ricoh G092 Service Manual

FIRMWARE UPDATE PROCEDURE

5.4.3 CONTROLLER/ENGINE FIRMWARE UPGRADE


CAUTION
1. Turn off the main switch whenever inserting or removing the PCMCIA
Memory card (IC card).
2. Open the front cover or right cover whenever updating the firmware.
3. Do not turn off the machine while downloading the firmware.

Engine Firmware

1. Prepare the PCMCIA memory card containing
the engine controller firmware (Engine ROM).
NOTE: The PCMCIA memory Card is also
referred to as an IC card, flash memory
card and memory card. Be certain to
only use the recommended card
(N803 6701).
2. Turn the main switch off.
3. Remove the cover [A].
4. Insert the PCMCIA memory card [B].
5. Open the front cover or right cover.
6. Turn the main switch on.
7. Wait until "Engine ROM." is displayed.
NOTE: 1) If you did not insert the correct PCMCIA memory card, the correct
message is not displayed. In this case, press the up-arrow key
("Exit" is displayed), press the enter key ("Close Front and/or Right
Cover" is displayed), and turn the main switch off. After this, insert
the correct PCMCIA card and resume upgrading.
2) If you have not fully inserted the PCMCIA memory card, the
message "Close Front and/or Right Cover" is displayed. In this case,
turn the main switch off, and fully insert the PCMCIA memory card.
After this, resume upgrading.
8. Press the On Line Key. "Updating" is displayed,
followed by underscores.
9. Check that the asterisks replace underscores
one by one.
G081/G092
[B]
[A]
G081S902.WMF
Engine ROM
Updating...
----------------
Updating...
!!!
5-30
G081S521.WMF
G081S522.WMF
-------------
G081S523.WMF
SM