Ricoh G092 Service Manual page 144

PRINTER ENGINE SERVICE MODE
Mode No.
5
(Class 1, 2, and 3)
990* [SMC print]
1 All
2 SP Mode
4 Logging
6 Non-Default
7 NIB Summary
991 [Jam OFF] Jam ON/OFF
1 Jam OFF
993 [Line Adj.] Line Point Adjustment
1 Timing(pages)
#
2 Manual
994 [Eng Err Stat] Engine Error Status
1 (7) 00000000 (0)
995 [Skew Adj.] Skew Adjustment
#
1 Skew Adj.
998 [ENG Mem Clear] Engine Memory Clear
2 Color Mis-Reg
G081/G092
Function / [ Setting ]
Prints SP setting data.
[0 ~ 255 / 0 / 0 /step]
• SP all print: All items printed out with SPs 5-990-2, -4,
-6, and -7.
• All: All SP mode settings
• Non-Default: SP settings that have been changed
from the defaults
Enables or disables jam detection.
[ 0 or 1 / 0 / – ]
0: Enable
1: Disable
The automatic line position adjustment is done after
printing the number of pages that is set with this SP.
[ 0 ~ 2000 / 250 / 1/page ]
NOTE: 0: Never done
Use to make a line position adjustment.
Display the engine error status.
Bit 7: The fuse did not blow after installing a new PCU(K)
Bit 6: The fuse did not blow after installing a new
PCU(YMC)
Bit 5: By-pass tray and duplex unit motor error
Bit 4: The color registration sensor cannot be calibrated.
Bit 3: Cannot measure the color registration sensor
value.
Bit 2: Cannot correct the color registration.
Bit 1: PCU(YMC) home position error.
Bit 0: Not used
Select color skew correction ON or OFF.
[ 0 or 1 / 1 / - ]
0: Off, 1: On
Clears the correction values for the color registration. Do
this SP mode after replacing the color registration board.
The correction values are set after the main power has
been turned on.
5-20 SM