Turntable Rotation Components; Turntable Rotation Assembly - Genie S-65 XC Service And Repair Manual

Service and Repair Manual

Turntable Rotation Components

8-1

Turntable Rotation Assembly

How to Remove the Turntable
Rotation Assembly
Note: When removing a hose assembly or fitting,
the O-ring (if equipped) on the fitting and/or hose
end must be replaced. All connections must be
torqued to specification during installation. Refer to
Specifications, Hydraulic Hose and Fitting Torque
Specifications.
Note: Perform this procedure with the machine on a
firm and level surface.
1 Secure the turntable from rotating with the
turntable rotation lock pin.
Note: The turntable rotation lock pin is located next
to the boom rest pad.
2 Tag, disconnect and plug the hydraulic hoses
from the turntable rotation drive motor. Cap the
fittings on the drive motor.
Bodily injury hazard. Spraying
hydraulic oil can penetrate and
burn skin. Loosen hydraulic
connections very slowly to allow
the oil pressure to dissipate
gradually. Do not allow oil to
squirt or spray.
92
3 Loosen the backlash pivot plate and
adjustment bolts.
4 Attach a suitable lifting device to the lifting
eyes on the drive hub assembly.
® ™ ® ™
S -60 XC • S -65 XC
1 backlash pivot plate
2 adjustment bolt with lock nut
3 backlash pivot plate mounting bolts
Part No. 1288652GT
September 2018