Table of Contents
Advertisement
Feed dog
To set the feed movement:
1. Lock the machine in place in the loop stroke position using the locking
The needle is in the loop stroke position.
2. Loosen the screws (4) on the eccentric (3).
3. Turn the eccentric (3) until the markings (2) line up.
4. Tighten the screws (4).
9.2.2 Setting the compensating weight
Order
Adjust the following setting first:
• Set the feed eccentric ( p. 44)
Proper setting
The screw of the compensating weight (2) must be parallel to the 1
in the rotational direction (5) of the eccentric (4).
Cover
• Remove the front cover ( p. 18)
Fig. 31: Setting the compensating weight
(1) - Screw
(2) - Compensating weight
(3) - Pull rod
To set the compensating weight:
1. Loosen the screw (1).
2. Turn the compensating weight (2) until the screw of the compensating
Service Instructions 1767 - 00.0 - 12/2016
pin (1).
①
②
③
weight (1) is parallel to the 1st screw in the rotational direction (5) of
the eccentric (4).
④
(4) - Eccentric
(5) - 1st screw in rotational direction
st
screw
⑤
45
Advertisement
Table of Contents
