3. Tighten the screw (1).
9.2.3 Setting the feed stroke eccentric
Cover
• Tilt the machine head ( p. 14)
Fig. 32: Setting the feed stroke eccentric
(1) - Locking pin
(2) - Markings
To set the feed stroke eccentric:
1. Lock the machine in place in the loop stroke position using the locking
The needle is in the loop stroke position.
2. Loosen the screws (4) on the eccentric (3).
3. Turn the eccentric (3) until the markings (2) line up.
4. Tighten the screws (4).
46
The distance between the compensating weight (2) and the pull rod (3)
is approx. 1 mm.
pin (1).
②
③
①
(3) - Eccentric
(4) - Screws
Service Instructions 1767 - 00.0 - 12/2016
Feed dog
④