Aligning the needle bar linkage
10.2 Aligning the needle bar linkage in the sewing direction
Cover
• Remove the front cover ( p. 18)
• Tilt the machine head ( p. 14)
Fig. 37: Aligning the needle bar linkage in the sewing direction
(1) - Screw
To align the needle bar linkage in the sewing direction:
1. Loosen the screw (1).
2. Move the needle bar linkage (2) such that the needle pierces in the
3. Tighten the screw (1).
Order
Then check the following setting:
• Loop stroke position ( p. 54)
Service Instructions 1767 - 00.0 - 12/2016
①
center of the needle hole.
②
(2) - Needle bar linkage
51