Table of Contents
Advertisement
Short thread cutter
17 Short thread cutter
Important
Correct setup of the short thread cutter requires that the necessary work
steps be performed in the order given in this chapter.
Requirements
• The needle bar must be at the top dead center when the handwheel
• The hook bearing must be set correctly ( p. 52).
Service Instructions 1767 - 00.0 - 12/2016
CAUTION
Risk of injury from sharp and moving parts!
Puncture or crushing possible.
Switch off the machine before adjusting the thread
cutter settings.
NOTICE
Property damage may occur!
Risk of breakage.
The reverse-motion lock for the bobbin case is on the thread-pulling
knife.
Never operate the machine without the thread-pulling knife.
position is 0° ( p. 33)
81
Advertisement
Table of Contents
