Working basis
There are 2 securing positions:
• Securing position 1: Loop stroke position
• Securing position 2: Handwheel zero position
Fig. 13: Locking the machine in place (2)
(5) - Slot
(6) - Locking opening
Locking the machine in place
To lock the machine in place:
1. Remove the plug from the locking opening (6).
2. Turn the handwheel until the appropriate slot (5) is in front of the locking
3. Insert the locking peg (7) with the appropriate end into the slot (5).
Removing the lock
To remove the lock:
1. Pull the locking peg (7) out of the slot (5).
2. Insert the plug into the locking opening (6).
Service Instructions 1767 - 00.0 - 12/2016
• 5 mm end in the large slot
• Setting the loop stroke and needle bar height
• 3 mm end in the small slot
• Setting the handwheel position and checking the top dead center
for the needle bar
⑤
⑥
opening (6):
• Small slot at handwheel position 0°
• Large slot at handwheel position 200 – 205°
(7) - Locking peg
⑦
25