Setting the feed-dog
3. Turn the stroke eccentric (2) such that the upper edge of the feed-dog
4. Tighten the setscrews (1).
8.3.2 Setting the compensating weight
Proper setting
Handwheel position 210°:
The setscrew for the compensating weight is parallel to the base
Cover
• Tilt the upper section ( p. 14)
Fig. 28: Setting the position of the compensating weight
①
②
Setting steps
1. Put the handwheel into the 210° position.
2. Unscrew the setscrew (1) and leave the hex key inserted in the set-
Service Instructions 867 - 03.0 - 10/2017
is in the upward movement and at the same height as the upper edge
of the throat plates.
WARNING
Risk of injury
Crushing injuries from moving parts.
Switch the sewing machine off before you check
and set the position of the compensating weight.
plate.
(1) - Setscrew
(2) - Compensating weight
screw.
③
(3) - Base plate
43