Table of Contents
Advertisement
Performing the basic settings of the eccentrics
5.2
Proper setting
The screw of the compensating weight is level with the1
tational direction of the eccentric that is used for the feed dog movement.
The compensating weight does not collide with the transmission lever on
the side.
Fig. 32: Adjusting the compensating weight
(1) - Screw
(2) - Compensating weight
To adjust the compensating weight:
1. Loosen the screw (1).
2. Adjust the compensating weight (2) such that screw (1) and screw (4)
Tighten the screw (1).
Service Instructions D869 e-con - 00.0 - 09/2023
Adjusting the compensating weight
①
②
are at the same height.
Make sure there is a gap between the compensating weight (2) and
the transmission lever (3).
st
screw in the ro-
④
③
(3) - Transmission lever
(4) - Screw
43
Advertisement
Table of Contents
