Table of Contents
Advertisement
5.2 Adjusting the compensating weight
Proper setting
The screw of the compensating weight is level with the 1
rotational direction of the eccentric that is used for the feed dog movement.
The compensating weight does not collide with the transmission lever on
the side.
Fig. 28: Adjusting the compensating weight
(1) - Screw
(2) - Compensating weight
To adjust the compensating weight:
1. Loosen the screw (1).
2. Adjust the compensating weight (2) such that screw (1) and screw (4)
3. Tighten the screw (1).
40
①
②
are at the same height.
Make sure there is a gap between the compensating weight (2) and
the transmission lever (3).
Performing the basic settings of the eccentrics
(3) - Transmission lever
(4) - Screw
Service Instructions D867 e-con - 00.0 - 08/2023
st
screw in the
④
③
Advertisement
Table of Contents
